Throttle Switch Assembly - 35300-300-672 - Honda CB750K0 1969-1970 CB750

Description

Throttle Switch Assembly - 35300-300-672 - Honda CB750K0
Reproduction throttle / starter / kill switch assembly for the Honda CB750K0. This has 1 threaded opening for the early single pull carburetors. Those carburetors are unique due to the single cable that splits into 4 cables (1 for each carburetor). It's common for the starter button's on these bikes to wear out due to arcing or they can break for various reasons. This is an easy part to replace if your wires aren't running through the handlebars, if they are, it requires removing the handlebars and feeding the wires through. Electric start sure is nice to have when it's reliable!
We also carry the left side switch assembly
here
.
If you are running aftermarket handlebars check to make sure the 27" wire harness is long enough. There is a locator pin built into the switch like the stock one. If aftermarket bars are installed a hole will need to be drilled.
This switch assembly will fit on many of the Honda CB's, check your wiring harness and make sure the connectors will work or you can replace the bullet connectors with connectors that match your harness. This switch is handy to have since you can turn the lights off to save on power consumption during daytime riding.
Wire harness is 27" long. (measured to the end of the shortest wire)
9 Male Bullet connectors - yellow, yellow/white line, yellow/red line, black (2), black/white line, white, brown/white line, blue
Replaces Honda Part Number: 35300-300-672
Note: This switch has a total of 9 wires.
Fits Honda:
CB750K0 - 1969-1970 (with 4into1 pull throttle cable)
4into1motorcycleparts
•
Store Policies